Challenger Lifts CL10V3-2 Versymmetric 10,000 Lbs Two Post Lift W/ 2' Extensions
Challenger Lifts CL10 SERIES
CL10series Versymmetric 2-Post Lifts feature a 2 Lifts in One Design to that provides the flexibility to lift vehicles asymmetrically or symmetrically within the same service bay. Other standard features of the Challenger CL10V3 2 Post Car Lift includes space saving column base plates with clear floor design, overhead cable equalization system, timesaving single-point or dual single-point mechanical lock release system, padded overhead shutoff bar and round double telescoping screw pads. Available in three Versymmetric® Productivity Configurations: Complete Productivity, Maximum Productivity and Max Plus Productivity.
- Versymmetric Plus 2-post lift w/ Conventional Power Controls, offset 3-stage front + 3-stage rear arms & single-point mechanical lock release w/ 2' column extensions (13' 8" ht. at full stroke)
- Industry first two post auto lift with Versymmetric® Plus offset 3-stage front arms + 3-stage rear arms
- Maximum arm sweep, reach and retraction meets the widest range of recommended lifting points
- Offset front arm provides single sweep spotting - no rolling vehicles back and forth to swing front arm clear of front tire
- Single push button powers lift up
- Two handed lowering operation -single point mechanical lock release / release valve
- Single point mechanical lock release system disengages both column locks simultaneously
|Lift Capacity*||10,000 lbs. (4535kg)|
A Rise Height1
B Column Height
C Cylinder Overall (Full Stroke)
|11' 11" (3632mm)|
D Adjustable Width Overall
|11' 6-1/2" / 11' 11" (3518mm / 3632mm)|
E Drive-Thru Clearance2
|100-1/2" / 105" (2553mm / 2667mm)|
|F Floor to Overhead Switch2||13' 2-1/2" (4026mm)|
G Front Arm Reach (Min/Max)
|Min. 19-13/16" / Max. 42" (956mm / 1524mm)|
H Rear Arm Reach (Min/Max)
|Min. 37-5/8" / Max. 60" (956mm / 1524mm)|
I Screw Pad Height3
|Min. 3-7/8" / Max. 6-1/2" (98mm / 161mm)|
J Inside Columns2
|110" / 114-1/2" (2794mm / 2908mm)|
K Low Lock Height
208v - 230v (Single Phase Standard)4
|Speed of Rise||48 seconds|
|Max. Load per Arm||2,500 lbs. (1134kg)|
|Ceiling Height Required||13' 9" (4191mm)|
*Lift capacity ratings are based on loads equally distributed on all four arms. 1 Rise Height is measured with adjustable screw pads in highest position. 2 Specifications are listed with lift at maximum width and/or height settings. 3 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm). 4 Optional 3 phase electrical also available (Not available for Quick Cycle models). Specify at time of order. Standard lift colors are Red and Blue. Optional colors available.
Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction.
Challenger Lifts Warranty Agreement
Challenger Lifts, Inc. lifts are guaranteed to the original owner. CLI shall repair or replace, at CLI option, for the full warranty period those parts that prove upon inspection to be defective and pay for reasonable costs of transportation and/or labor for replacement of said parts for the warranty period stated below. This warranty shall not apply unless the product is installed, used and maintained according to CLI’s specifications set forth in CLI’s installation, operation and maintenance instructions. Use of any unapproved parts or accessories will void your warranty. This limited warranty extends only to the original purchaser and is not transferable. This warranty is valid only if the product has been registered with Challenger Lift, Inc., www.challengerlifts.com.
This warranty does not cover normal maintenance or adjustments, damage or malfunction caused by improper handling, installation, abuse, misuse, negligence, carelessness of operation, or normal wear and tear. In addition, this warranty does not cover equipment when repairs have been attempted or made by anyone other than a CLI authorized service representative.
This warranty is exclusive and is in lieu of all other warranties expressed or implied including any implied warranty of fitness for a particular purpose, which implied warranties are expressly excluded. No employee, agent, representative, dealer or other person or entity is authorized to give any warranties of any nature on behalf of CLI.
The remedies described are exclusive and in no event shall CLI, Inc. be liable for special, consequential or incidental damages for the breach of or delay in performance of the warranty. This warranty shall be governed by the Commonwealth of Kentucky, and shall be subject to the exclusive jurisdiction of the Court in the Commonwealth of Kentucky in the County of Jefferson.
Functional parts are any wear items, as defined from time to time by Challenger Lifts. Examples include power units, cylinders, sheaves, hoses, cables, controls, etc. and may differ depending on the model of lift.
Structural parts are items, as defined from time to time by Challenger Lifts, Inc. that are not Functional Parts and include items like carriage, columns, arms, runways, plungers, etc. and may differ depending on the type of lift.
Note: WARRANTY CARD MUST BE COMPLETED AND RETURNED UPON INSTALLATION FOR VALIDATION or WARRANTY PERIOD WILL BEGIN FROM INVOICE DATE OF LIFT PURCHASE. WARRANTY MAY ALSO BE VALIDATED BY REGISTERING ONLINE @ challengerlifts.com/register.shtml
|Description||Model/Series||Labor||Functional Parts||Structural parts||Extended Warranty Available|
|CL10||CL10||1 Year||2 Years||5 Years||Yes|
|10K 2-Post, 9K 2-Post||LE10, SA10, CLFP9||1 Year||1 Year||5 Years||No|
|12K, 15K, 18K 2-Post||CL12, 15000, 18000||1 Year||2 Years||5 Years||Yes|
|8K Inground||EVW0820||1 Year||2 Years||2 years||No|
|10K Ingrounds||EV1020||1 Year||2 Years||5 Years||Yes|
|12K, 15K Ingrounds||EV1220, EV1520||1 Year||1 Year||5 Years||Yes|
|14K 4-Post||4P14||1 Year||1 Year||5 Years||No|
|15K 4-Post||4015||1 Year||2 Years||5 Years||No|
|30K 4-Post Cable Drive||4030||1 Year||2 Years||5 Years||No|
|30K, 40K, 60K Chain Drive||44030, 44040, 44060||1 Year||1 Year||1 Year||No|
|Rolling Jacks||RJ, SAJ||1 Year||1 Year||1 Year||No|
|Mid and Short Rise||MR-6, SRM-10||1 Year||1 Year||1 Year||No|
|Scissors||SX14, DX77||1 Year||1 Year||1 Year||No|
|Mobiles||CLHM||1 Year||1 Year||5 Years||No|
|Replacement Parts||90 days||No|
An extended warranty is available for purchase for NEW CL/EV Series lifts. The Extended Warranty must be purchased within 30 days of lift invoice, and extends the Functional Parts coverage by an additional 3 years (5 Years total). Lift must be installed by and authorized Challenger installer. Extended warranty does not apply to accessories.