Challenger Lifts CL10V3-DPC Versymmetric 10,000 Lbs 2-Post Car Lift W/ Dual Pendant Controls
- Challenger Lifts
Challenger Lifts Max Plus Productivity CL10V3-DPC Versymmetric Two Post Car Lift
CL10series Versymmetric® 2-Post Lifts feature a 2 Lifts in One Design to that provides the flexibility to lift vehicles asymmetrically or symmetrically within the same service bay. Other standard features include space saving column base plates with clear floor design, overhead cable equalization system, timesaving single-point or dual single-point mechanical lock release system, padded overhead shutoff bar and round double telescoping screw pads.
Challenger Lifts CL10V3-DPC Two Post Car Lift Versymmetric Plus 2-post lift w/ Dual Pendant Power Controls, offset 3-stage front + 3-stage rear arms & dual single-point mechanical lock release. Includes Stack Adaptor Kit (Part#10315), Document Caddy (Part #10320) and Pendant Holder (Part #10321), (11' 11" ht. at full stroke) (Single phase only)
- · Max Plus Productivity (CL10V3DPC) - Dual Pendant Power Controls, Stack Adapter Kit and Document Caddy with Versymmetric® Plus offset 3-stage front + 3-stage rear arms
- · 11´ 8” standard height allows lift to be placed in standard service bay with 12´ ceiling
- · Adjustable arm restraint shafts compensate for uneven floors
- · Grease fittings located on arm pin bushings minimize corrosion to keep arms swinging freely
- · Available 2´ and 3´ column extensions enable technician to work at an ergonomic height when servicing taller vehicles
- · Double Telescoping Screw Pads adjust to multiple heights minimizing the need for adapters
- · 48” elongated carriage design decreases load on bearing
- · Heavy-Duty 5 diameter pulley and 5/16 cable reduces stress on equalization system and increases cable life
- · Padded overhead shut off system prevents vehicle damage
- · Single-point mechanical lock release system allows technician to disengage both column locks simultaneously
- · Rubber door guards protect vehicles from door damage
- · Made in USA
10,000 lbs. (4535kg)
A Rise Height1
B Column Height
C Cylinder Overall
11' 11" (3632mm)
D Adjustable Width Overall
11' 6-1/2" / 11' 11"
(3518mm / 3632mm)
E Drive-Thru Clearance2
100-1/2" / 105"
(2553mm / 2667mm)
F Floor to Overhead Switch2
G Front Arm Reach (Min/Max)
Min. 19-13/16" / Max. 42"
(956mm / 1524mm)
H Rear Arm Reach (Min/Max)
Min. 37-5/8" / Max. 60"
(956mm / 1524mm)
I Screw Pad Height3
Min. 3-7/8" / Max. 6-1/2"
(98mm / 161mm)
J Inside Columns2
110" / 114-1/2"
(2794mm / 2908mm)
K Low Lock Height
208v - 230v (Single Phase Standard)4
Speed of Rise
Max. Load per Arm
2,500 lbs. (1134kg)
Ceiling Height Required
*Lift capacity ratings are based on loads equally distributed on all four arms. 1 Rise Height is measured with adjustable screw pads in highest position. 2 Specifications are listed with lift at maximum width and/or height settings. 3 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm). 4 Optional 3 phase electrical also available (Not available for Quick Cycle models). Specify at time of order. Standard lift colors are Red and Blue. Optional colors available.
Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction.
Challenger Lifts Warranty Agreement
Challenger Lifts, Inc. lifts are guaranteed to the original owner. CLI shall repair or replace, at CLI option, for the full warranty period those parts that prove upon inspection to be defective and pay for reasonable costs of transportation and/or labor for replacement of said parts for the warranty period stated below. This warranty shall not apply unless the product is installed, used and maintained according to CLI’s specifications set forth in CLI’s installation, operation and maintenance instructions. Use of any unapproved parts or accessories will void your warranty. This limited warranty extends only to the original purchaser and is not transferable. This warranty is valid only if the product has been registered with Challenger Lift, Inc., www.challengerlifts.com.
This warranty does not cover normal maintenance or adjustments, damage or malfunction caused by improper handling, installation, abuse, misuse, negligence, carelessness of operation, or normal wear and tear. In addition, this warranty does not cover equipment when repairs have been attempted or made by anyone other than a CLI authorized service representative.
This warranty is exclusive and is in lieu of all other warranties expressed or implied including any implied warranty of fitness for a particular purpose, which implied warranties are expressly excluded. No employee, agent, representative, dealer or other person or entity is authorized to give any warranties of any nature on behalf of CLI.
The remedies described are exclusive and in no event shall CLI, Inc. be liable for special, consequential or incidental damages for the breach of or delay in performance of the warranty. This warranty shall be governed by the Commonwealth of Kentucky, and shall be subject to the exclusive jurisdiction of the Court in the Commonwealth of Kentucky in the County of Jefferson.
Functional parts are any wear items, as defined from time to time by Challenger Lifts. Examples include power units, cylinders, sheaves, hoses, cables, controls, etc. and may differ depending on the model of lift.
Structural parts are items, as defined from time to time by Challenger Lifts, Inc. that are not Functional Parts and include items like carriage, columns, arms, runways, plungers, etc. and may differ depending on the type of lift.
Note: WARRANTY CARD MUST BE COMPLETED AND RETURNED UPON INSTALLATION FOR VALIDATION or WARRANTY PERIOD WILL BEGIN FROM INVOICE DATE OF LIFT PURCHASE. WARRANTY MAY ALSO BE VALIDATED BY REGISTERING ONLINE @ challengerlifts.com/register.shtml
|Description||Model/Series||Labor||Functional Parts||Structural parts||Extended Warranty Available|
|CL10||CL10||1 Year||2 Years||5 Years||Yes|
|10K 2-Post, 9K 2-Post||LE10, SA10, CLFP9||1 Year||1 Year||5 Years||No|
|12K, 15K, 18K 2-Post||CL12, 15000, 18000||1 Year||2 Years||5 Years||Yes|
|8K Inground||EVW0820||1 Year||2 Years||2 years||No|
|10K Ingrounds||EV1020||1 Year||2 Years||5 Years||Yes|
|12K, 15K Ingrounds||EV1220, EV1520||1 Year||1 Year||5 Years||Yes|
|14K 4-Post||4P14||1 Year||1 Year||5 Years||No|
|15K 4-Post||4015||1 Year||2 Years||5 Years||No|
|30K 4-Post Cable Drive||4030||1 Year||2 Years||5 Years||No|
|30K, 40K, 60K Chain Drive||44030, 44040, 44060||1 Year||1 Year||1 Year||No|
|Rolling Jacks||RJ, SAJ||1 Year||1 Year||1 Year||No|
|Mid and Short Rise||MR-6, SRM-10||1 Year||1 Year||1 Year||No|
|Scissors||SX14, DX77||1 Year||1 Year||1 Year||No|
|Mobiles||CLHM||1 Year||1 Year||5 Years||No|
|Replacement Parts||90 days||No|
An extended warranty is available for purchase for NEW CL/EV Series lifts. The Extended Warranty must be purchased within 30 days of lift invoice, and extends the Functional Parts coverage by an additional 3 years (5 Years total). Lift must be installed by and authorized Challenger installer. Extended warranty does not apply to accessories.
Frequently Bought Together
Total Price:+ Add to Cart
Please choose options for all selected products