Challenger Lifts EV1020-QC Quick Cycle 10,000 Lbs Inground Car Lifts
Overall Features of EV1020 Inground Car Lift Series
Challenger’s electric hydraulic cassette-style 10,000 lb. capacity in ground lift meets the demands of professional service facilities. With a smaller footprint, your shop can maximize service bays. The EV1020 is available with either 3-stage front and rear arms or a fixed drive-on pad. Our added Quick Cycle models can rise in just 27 seconds and lower in only 17 seconds. Expand your service potential with our most versatile, easy-to-operate in ground lift.
Features
- 10,000 lb. lift capacity
- 3-stage front and 3-stage rear arms provide access to the lift points of a wide range of cars and trucks, maximizing revenue potential
- Also available with a drive-on style pad (XP9) to aid in quick vehicle spotting for express bays
- 8 1/2” diameter chrome pistons provide greater stability under load
- Chrome non-breathing ram style cylinder provides for longer lift life
- Enhanced raised wiper at top and bottom of bearing provides better grease retention and minimizes contaminates from entering into bearings
- Long bearing contact provides increased stability
- Mechanical lock engages every 3? allowing ergonomic working height for technicians to increase productivity and minimize fatigue
- Stainless steel air lock release cylinder promotes longer working life with its corrosion resistant design
- Fully-contained and sealed recycled polymer cassette tub eliminates risk of hydraulic fluid seeping into the ground
- Premium double telescoping screw pads adjust to multiple heights minimizing the need for adapters
- 87″ drive-thru accommodates wider vehicles, minimizes tire damage and provides for easy drive-on
- Quick Cycle™ models reduce vehicle travel time by 30 percent
- Wide range of upgrades to further customize your fleet
- Premium powder coat finish on bolsters and arms provides long-lasting durability
Specific Features of EV1020-QC
Model Number | EV1020-QC |
Lifting Capacity | 10,000 lbs. |
Arms | 3-stage front/3-stage rear |
Stroke | 68” |
Rise Height | 74” |
Width Overall | 97" |
Drive-Thru Clearance | 87” |
Reach (Arm Minimum) | 19.625” |
Reach (Arm Maximum) | 42.125” |
Screw Pad Height | 3.875” - 6” |
Capacity | 2,500 lbs. per arm |
Guide Plunger Diam. | 8.5” |
Motor / Voltage | 2HP, 208v-230v, 60Hz, 1Ph |
Speed of Rise | 27 s |
Air Required | 90 - 120 psi |
ALI/ETL Certified | Yes |
Super Structure Colors | Red, Blue, Black |
Additional Parts and Accessories
Part No. | Description |
16902 | Bench Mount Lever (BML) |
10300 | Pair of luxury car adapters |
10313 | Pair of 6" Stack Adapter Extensions |
10315 | Stack Adapter Kit - includes (4) 3 in. stack extensions, (2) 6 in. stack extensions & (2) organizer racks with hardware |
15060 | Floor-mounted Power Unit Stand |
SD100 | Cassette Lift Automatic Liquid Removal System |
CSGREASE | Extra Tube of Grease for Electric / Hydraulic Inground Lifts |
3PHCS | Power Unit Upgrade to 3-Phase |
Download
Brochure
Spec Sheet
Manual
Quick Cycle Manual
Other Models
Model Number | EV1020 | EV1020-QC | EV1020XP9 | EV1020XP9-QC |
Lifting Capacity | 10,000 lbs. | 10,000 lbs. | 9,000 lbs. | 9,000 lbs. |
Arms | 3-stage front/3-stage rear | 3-stage front/3-stage rear | n/a | n/a |
Stroke | 68” | 68” | 68” | 68” |
Rise Height | 74” | 74” | 70” | 70” |
Width Overall | 97" | 97" | 79.75” | 79.75” |
Drive-Thru Clearance | 87” | 87” | - | - |
Reach (Arm Minimum) | 19.625” | 19.625” | - | - |
Reach (Arm Maximum) | 42.125” | 42.125” | - | - |
Screw Pad Height | 3.875” - 6” | 3.875” - 6” | Minimum Pad Height: 2.25" | Minimum Pad Height: 2.25" |
Capacity | 2,500 lbs. per arm | 2,500 lbs. per arm | 4,500 lb. per pad | 4,500 lb. per pad |
Guide Plunger Diam. | 8.5” | 8.5” | 8.5” | 8.5" |
Motor / Voltage | 2HP, 208v-230v, 60Hz, 1Ph | 2HP, 208v-230v, 60Hz, 1Ph | 2HP, 208v-230v, 60Hz, 1Ph | 2HP, 208v-230v, 60Hz, 1Ph |
Speed of Rise | 38 s | 27 s | 38 s | 27 s |
Air Required | 90 - 120 psi | 90 - 120 psi | 90 - 120 psi | 90 - 120 psi |
ALI/ETL Certified | Yes | Yes | Yes | Yes |
Super Structure Colors | Red, Blue, Black | Red, Blue, Black | Black | Black |
Challenger Lifts Warranty Agreement
Challenger Lifts, Inc. lifts are guaranteed to the original owner. CLI shall repair or replace, at CLI option, for the full warranty period those parts that prove upon inspection to be defective and pay for reasonable costs of transportation and/or labor for replacement of said parts for the warranty period stated below. This warranty shall not apply unless the product is installed, used and maintained according to CLI’s specifications set forth in CLI’s installation, operation and maintenance instructions. Use of any unapproved parts or accessories will void your warranty. This limited warranty extends only to the original purchaser and is not transferable. This warranty is valid only if the product has been registered with Challenger Lift, Inc., www.challengerlifts.com.
This warranty does not cover normal maintenance or adjustments, damage or malfunction caused by improper handling, installation, abuse, misuse, negligence, carelessness of operation, or normal wear and tear. In addition, this warranty does not cover equipment when repairs have been attempted or made by anyone other than a CLI authorized service representative.
This warranty is exclusive and is in lieu of all other warranties expressed or implied including any implied warranty of fitness for a particular purpose, which implied warranties are expressly excluded. No employee, agent, representative, dealer or other person or entity is authorized to give any warranties of any nature on behalf of CLI.
The remedies described are exclusive and in no event shall CLI, Inc. be liable for special, consequential or incidental damages for the breach of or delay in performance of the warranty. This warranty shall be governed by the Commonwealth of Kentucky, and shall be subject to the exclusive jurisdiction of the Court in the Commonwealth of Kentucky in the County of Jefferson.
Functional parts are any wear items, as defined from time to time by Challenger Lifts. Examples include power units, cylinders, sheaves, hoses, cables, controls, etc. and may differ depending on the model of lift.
Structural parts are items, as defined from time to time by Challenger Lifts, Inc. that are not Functional Parts and include items like carriage, columns, arms, runways, plungers, etc. and may differ depending on the type of lift.
Note: WARRANTY CARD MUST BE COMPLETED AND RETURNED UPON INSTALLATION FOR VALIDATION or WARRANTY PERIOD WILL BEGIN FROM INVOICE DATE OF LIFT PURCHASE. WARRANTY MAY ALSO BE VALIDATED BY REGISTERING ONLINE @ challengerlifts.com/register.shtml
Description | Model/Series | Labor | Functional Parts | Structural parts | Extended Warranty Available |
CL10 | CL10 | 1 Year | 2 Years | 5 Years | Yes |
10K 2-Post, 9K 2-Post | LE10, SA10, CLFP9 | 1 Year | 1 Year | 5 Years | No |
12K, 15K, 18K 2-Post | CL12, 15000, 18000 | 1 Year | 2 Years | 5 Years | Yes |
8K Inground | EVW0820 | 1 Year | 2 Years | 2 years | No |
10K Ingrounds | EV1020 | 1 Year | 2 Years | 5 Years | Yes |
12K, 15K Ingrounds | EV1220, EV1520 | 1 Year | 1 Year | 5 Years | Yes |
14K 4-Post | 4P14 | 1 Year | 1 Year | 5 Years | No |
15K 4-Post | 4015 | 1 Year | 2 Years | 5 Years | No |
30K 4-Post Cable Drive | 4030 | 1 Year | 2 Years | 5 Years | No |
30K, 40K, 60K Chain Drive | 44030, 44040, 44060 | 1 Year | 1 Year | 1 Year | No |
Rolling Jacks | RJ, SAJ | 1 Year | 1 Year | 1 Year | No |
Mid and Short Rise | MR-6, SRM-10 | 1 Year | 1 Year | 1 Year | No |
Scissors | SX14, DX77 | 1 Year | 1 Year | 1 Year | No |
Mobiles | CLHM | 1 Year | 1 Year | 5 Years | No |
Accessories | 90 days | No | |||
Replacement Parts | 90 days | No |
Extended Warranty
An extended warranty is available for purchase for NEW CL/EV Series lifts. The Extended Warranty must be purchased within 30 days of lift invoice, and extends the Functional Parts coverage by an additional 3 years (5 Years total). Lift must be installed by and authorized Challenger installer. Extended warranty does not apply to accessories.