RGI VECTOR 150 Single Wall Semi Down Draft Spray Booth

RGI Spray Booths

Factory Shipped

Total Price:
$16,469.00 $14,875.00
(You save $1,594.00)
Shipping Calculated at Checkout
Shipping Calculated at Checkout

Factory Shipped

RGI VECTOR 150 Single Wall Semi Down Draft Spray Booth 

The Vector 150 is a quality and economical booth made for performance and durability. This booth was created for start-up and small shops looking for a great performing, yet economical booth. As seen on the left, air enters the booth through the top-front filtered plenum and is exhausted at the rear-center plenum.

rgi vector 150

The Vector 150 pulls clean air from the upper ceiling through a filter bank located on rear-center exhaust plenum.


Heavy Duty Construction:
Our booths are constructed of 18-gauge, pre-punched single wall panels, our design allows for easy assembly.

Fans & Motors:
(1) 30" Fans 12,600 CFM and (1) 3PH Motor

(16) Exhaust filters and (2) Intake filter blanket frames

(3) Tri-fold doors with observation windows and (1) Man access door with observation window

Full booth illumination from four-tube, 4’ light fixtures with 4 fluorescent lamps, ETL listed


  • Outside Dimension. 14'-4"Wide x 24'-4"Long x11'-2"High
  • Inside Dimension. 14'Wide x 22'-6"Long x 9'High
  • (1) Set of Drive in doors, opening Dim. 9'x9' TRI-FOLD DOBLE WALL
  • (1) Side access man door Dim. 3'x7'
  • (10) 4 Tube fluorescent T8 light fixtures 120v. (bulbs not included)
  • (1) 30" Dia. Tubeaxial belt drive exhaust fan cfm's @ .250" SP=13,180
  • (1) 3hp 3ph motor 208-230/460v. 60 hz
  • (1) Mark dywer manometer kit defines air flow pressure
  • (16) Exhaust filters w/ (32) exhaust filter grids
  • (2) Intake filter pads 37”x117”
  • (1)Hardware set for assembly; nuts & bolts, screws, door foam seal, door latches, door handles and flat rubber for bottom of entry doors for a tight seal.
  • (1) Installation exploded view drawings booth elevations and specifications.
  • All components are UL approved

Booth Upgrades

  • Booth Extension - Need more space to spray? Extend the lenght of your booth.
  • Drive-Thru - Add automotive exit doors to the booth to increase production time.
  • Observation Windows - Need more quality control? Add more windows to increase supervision.

Booth Models

  • 24' Model 14' -4" (w) x 24'-4" (l) x 9'-2" (h)
  • 27' Model 14' -4" (w) x 27'-4" (l) x 9'-2" (h)
  • 30' Model 14' -4" (w) x 30'-4" (l) x 9'-2" (h)


  • Powder coating ultra white inside and out. Recommended for premium inside illumination and booth panels protection from corrosion and outside elements.
  • Pre-fab Electrical control Kit with Interlock Combo Kit
  • Pre-Intake Filter plenum box Combo Kit 
  • 1 Phase Upgrade
  • Fire Suppression System 
  • LED Upgrade
  • 30" Dia. 12 Ft. Exhaust Duct Kit, 2 plain duct pieces, ring connector to fan, rain guards, counter flashing and vertical damper cap.  

Single Wall Semi Down Draft Spray Booth

All paint spray booths manufactured by RGI Mfg. Co. (RGI) are warranted by RGI, against defects in workmanship for materials under normal use for one year after the date of purchase from RGI. Any part which is determined by RGI to be defective in material or workmanship and is returned to RGI, shipping cost prepaid, will be, as the exclusive remedy, repaired or replaced at RGI’s option.

Any liability of consequential and incidental damages is expressly disclaimed. RGI’s liability in all events is limited to, and shall not exceed, the replacement price of the part.

All states and localities have codes and regulations governing the construction, installation and/or use of paint spray booths, which may be interpreted differently from those in neighboring areas. While RGI attempts to assure that it’s spray booths comply with such codes, it cannot guarantee compliance, and cannot be responsible for how the spraybooth is installed or used. Before the purchase and use of a spray booth, please review the spray booth application, and national and local codes and regulations, and be sure that the product, installation and use comply with them.

Unless otherwise specified, RGI accepts no responsibility for loss or damages to products shipped from RGI unless said products are shipped freight prepaid by RGI. Exception: If it is determined by RGI that loss or damage occurred as a result of negligence on the part of RGI, RGI will replace the lost or damaged articles. If such a determination is made by RGI, replacement of lost or damaged articles will occur only after receipt of a written request, from the purchaser.

Frequently Bought Together

Please choose options for all selected products

  • Choose Options