Dent Fix Equipment DF-800MC/50 StapleClip - M
Product Details
Pack of 50 stainless steel DF-800MC/50 M-Clip Breakaway StapleClips. Intended for outside corner application points on thermoplastic parts such as bumpers and clips. The inside corner of a broken part might not be accessible from the backside. Using the M-Clip on the front of the repair not only allows for the repair to be performed, but also saves time by not having to remove the part from the vehicle. These areas are usually right angles, bends and joints.
Breakaway StapleClips
This small design element will cut cycle time and save technicians extra steps. The leads are notched like someone took an axe to a tree, allowing them to be snapped off with a hand, instead of having to go back with snips. The time savings does not stop there: if sunken deep enough the leads will break below the surface of the plastic eliminating the need to go back over with a grinder later. Over time these simple improvements make the difference in profitability and not going over the allocated time.
Consumable replacement part for the DF-400BR, DF-800BR, or any other Hot Stapler. (Sold Separately)
WARRANTY POLICY
Used Product Warranty Claims: A product is considered used when it has been used for more than 1 week and is no longer re-sellable. All used product warranty claims are to be returned to Dent Fix freight pre-paid. All used product will be repaired or replaced and returned to you via regular freight pre-paid. Expedited return shipments are sent freight collect. Whether to repair or replace is at our sole discretion.
Air Tools: All our air tools carry a 1-year warranty against manufacturing defects. Customer abuse, such as a lack of proper maintenance, and the damage caused therein is not covered under warranty.
?
Consumable: Any item that by its nature or design that wears, gets used up or is permanently changed by its usage is considered a consumable item. Drill bits are a consumable item and as such carry no warranties expressed or implied. There are several procedures the user can implement in order to extend drill bit life, but ultimately the drill bit will break or dull. It is up to the technician to ensure proper usage.
Items with Specific Warranties:
DF-1 Stud Welder: Lifetime – Chuck of slide hammer & Transformer. 5 year – Trigger switch.
DF-505 “The Maxi”: 5 years on internal components.
DF-601 Surge Protector: Lifetime – return for replacement if red L.E.D. does not light.
DF-900W Aluspot Stud Welder: 5 Years - Internal components.
DF-SPR67 Self-Piercing Riveter: 1 Year - Internal components.
DF-EZN1 & DF-EZN1G EZ Nitrogen Welders - 5 Years - Internal components.
Other warranties may apply, please check your product sheet for more information. This warranty does not apply where: repairs have been made or attempted without the assistance of or by an authorized Dent Fix Repair Center; repairs are required because of normal wear and tear; the tool has been abused or misused or improperly maintained; alterations have been made to the tool.
In no event shall DENT FIX be liable for any indirect, incidental or consequential damages from the sale or use of the product. This disclaimer applies to both during and after the term of the warranty.
DENT FIX disclaims liability for any implied warranties, including implied warranties of “merchantability” and “fitness for a specific purpose”, after the term of this warranty.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitations of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
?
QUESTIONS PLEASE CALL 800-562-4791
