RGI IOF Open Face Spray Booth
Air flow description
This ETL-listed 6' open-face spray booth draws air through the open front which is then exhausted through the back wall filters. Choose a standard or rear exhaust configuration.
Model Shown: IOF 888 8' L -8' W - 8' H
Includes
- Interior Dim. 7'-8''Wide X 8'Long X 8'High.
- Exterior Inside Work Area Dim. 8'W X 8'L X 8'H
- (1) 4 Led T8 Light Fixtures 120V
- (1) 24'' Dia. Tube Axial Belt Drive Exhaust Fan Cfm @ .250'' S.P=9,350
- (1) 2Hp 3Ph Motor 230/460V. 60 Hz
- (1) Mark Dywer Manometer Kit Defines Air Flow Pressure.
- (1) Exhaust Filter Pad.
- Intake Filter Pads.
- (1)Hardware Set For Assembly; Nuts & Bolts, Screws, Door Foam Seal, Door Latches, Door Handles And Flat Rubber For Bottom Of Entry.
CONSTRUCTION
Pre-punched single wall panels.
18 ga. galvanized steel panels.
Self-support airtight construction.
MECHANICAL & MOTOR
(1) - 30" 12,900 CFM Tube-axial fan.
(1) - 3HP-3PH-240v Baldor motor.
FILTRATION
(26) - Exhaust filters frame.
(4) - Intake filters frame.
CURTAIN SYSTEM
Tri-color curtain system.
Straight track 10' long.
Two- wheel nylon roller.
LIGHTING
(2) upper horizontal light fixtures.
Energy efficient ballast 120V 60Hz
Different booth sizes available (Call for pricing)
Model | Wide | Long | High | Fan | Motor | Light |
IOF-888 | 8' | 8' | 8' | 24" | 2hp | 1 |
IOF-8810 | 8' | 8' | 10' | 24" | 3hp | 1 |
IOF-81010 | 8' | 10' | 10' | 24" | 3hp | 2 |
IOF-101010 | 10’ | 10’ | 10’ | 30" | 2hp | 2 |
IOF-101210 | 10’ | 12’ | 10’ | 30" | 3hp | 2 |
IOF-101212 | 10' | 12' | 12' | 30" | 3hp | 2 |
IOF-1288 | 12' | 8' | 8' | 30" | 2hp | 2 |
IOF-1299 | 12' | 9' | 9' | 30” | 2HP | 2 |
IOF-12109 | 12' | 10' | 9' | 34” | 3hp | 2 |
IOF-12129 | 12' | 12' | 9' | 34” | 3hp | 2 |
IOF-1488 | 14' | 8' | 8' | 30" | 3hp | 3 |
IOF-14108 | 14' | 10' | 8' | 30" | 3hp | 3 |
IOF-14108 | 14' | 10' | 9' | 34" | 3hp | 4 |
IOF-141410 | 14' | 14' | 9' | 34” | 5hp | 4 |
IOF-141410 | 14' | 16' | 9' | 34” | 5hp | 4 |
IOF-141610 | 14' | 16' | 9' | 34” | 7.5hp | 4 |
IOF-1688 | 16' | 8' | 8' | 34” | 5hp | 4 |
IOG-16108 | 16' | 10' | 8' | 34” | 5hp | 4 |
IOF-161010 | 16' | 10' | 10' | 34” | 5hp | 4 |
IOF-161210 | 16' | 12' | 10' | 34” | 5hp | 4 |
IOG-12108 | 12' | 10' | 8' | 30" | 3hp | 2 |
IOF-14108 | 14' | 10' | 8' | 30" | 3hp | 3 |
IOF-16108 | 16' | 10' | 8' | 34” | 5hp | 4 |
All paint spray booths manufactured by RGI Mfg. Co. (RGI) are warranted by RGI, against defects in workmanship for materials under normal use for one year after the date of purchase from RGI. Any part which is determined by RGI to be defective in material or workmanship and is returned to RGI, shipping cost prepaid, will be, as the exclusive remedy, repaired or replaced at RGI’s option.
LIMITATIONS OF LIABILITY
Any liability of consequential and incidental damages is expressly disclaimed. RGI’s liability in all events is limited to, and shall not exceed, the replacement price of the part.
PRODUCT SUITABILITY
All states and localities have codes and regulations governing the construction, installation and/or use of paint spray booths, which may be interpreted differently from those in neighboring areas. While RGI attempts to assure that it’s spray booths comply with such codes, it cannot guarantee compliance, and cannot be responsible for how the spraybooth is installed or used. Before the purchase and use of a spray booth, please review the spray booth application, and national and local codes and regulations, and be sure that the product, installation and use comply with them.
FREIGHT LOSS OR DAMAGE POLICY
Unless otherwise specified, RGI accepts no responsibility for loss or damages to products shipped from RGI unless said products are shipped freight prepaid by RGI. Exception: If it is determined by RGI that loss or damage occurred as a result of negligence on the part of RGI, RGI will replace the lost or damaged articles. If such a determination is made by RGI, replacement of lost or damaged articles will occur only after receipt of a written request, from the purchaser.