BendPak SP-7X Series Arm Kit for Full-Rise Scissors Lift

BendPak

SKU:
BP-5210214
Condition:
New
Availability:
Tax and shipping surcharges may apply.
Shipping:
Free Shipping
Total Price:
MSRP: $1,290.00
$1,075.00
(You save  $215.00 )
Adding to cart… The item has been added

jmc-shipping-button.pngBendPak SP-7X Series Arm Kit for Full-Rise Scissors Lift

BendPak SP-7X Series Arm Kit Arm Kit / Fits Full-Rise Scissors Lift Models / SP-7X Series

Optional Lift Arm Kit

If you purchased the optional Lift Arm Kit, this section describes how to use it. The Kit comes with four Lift Arms. To use the Lift Arms, you hook them on the outside edge of a Platform, put on the desired Pads, drive the Vehicle over the Lift, then position the Pads under the manufacturer’s recommended Lifting Points for the Vehicle you are raising. 

The maximum Vehicle weight you can raise using all four Lift Arms (which must always be used four at a time) is 4,800 lb / 2,177 kg. Do not raise a Vehicle that weighs more than this; if you do, you could damage the Lift or the Vehicle, you put at risk everyone near the Lift, and you void your warranty. Each Lift Arm is rated for a maximum of 1,200 lb / 544 kg; never put more than this on one Lift Arm. 

You position the Pads by sliding the Lift Arms along the outside edge of the Platform. 

Each Lift Arm can be fitted with either a Short Pad or a Tall Pad/Adapter/Base combination, all of which come with the Lift Arm Kit. 

sp-7x-series-arm-kit-diagram.png

Important:

If you are going to be raising Vehicles with body-on-frame construction (compared to unibody construction), BendPak recommends purchasing 35 mm Frame Cradle Pads for safer lifting. Make sure to order the 35 mm Pin Diameter option

If you get the Frame Cradle Pads, they replace the Tall Pad in the Tall Pad/Adapter/Base combination. 

To switch between Short Pads and the Tall Pad/Adapter/Base, remove the Lock Screw on the end of the Lift Arm, remove the current Pad, slide on the desired Pad, and then replace the Lock Screw. 

If you are using the Tall Pad/Adapter/Base combination, you can use it with or without the Adapter.

 

Specifications

SKU 5210214
Weight 111.00 LBS
Width 29.00 (in)
Height 8.00 (in)
Depth 17.00 (in

 

**Bendpak charges sales tax in California**
***It is the buyer's responsibility to unload the freight at their location.